When you think about upholstery, it sounds very overwhelming. Like something that you should leave to the pros, right? Well, if you know me, I’ll try anything! And upholstery is no exception — although this little chair did sit in my home for about a year before I mustered up the courage to tackle it.
This job was a part of a custom design project that I was blessed to be able to do. Hoping to show you the entire room soon!
The first step to upholstery is to remove the old fabric. It’s helpful to pickup some upholstery tools from your local craft store to assist with removal of staples, etc. The best tip I can give you is to take lots of photos as you are taking apart the chair. That way you know how everything is supposed to go back together once you’re ready to staple on your new fabric.
Once everything is removed, this is your opportunity to paint or refinish the base of your chair. I chose a custom-mixed bright pink, distressed it, and finished it off with Annie Sloan Dark Wax. The dark wax really helped bring out the detail and beauty of the frame.
When you’re ready to put your chair back together, trace and cut your new fabric from the old fabric pieces and start putting each piece back the same way it came off. You will need a heavy-duty staple gun and a pair of strong, steady hands! Each piece will need to be stapled first at the top, then bottom, then each side — pulling the fabric snug as you staple around to make sure it fits evenly.
Once the fabric is complete, you’ll need to cover all those staples with something. If you choose nailheads, use a rubber mallet (also found at your local craft store). This takes some practice and I would say was the hardest part of the project! Another option is to hot glue fabric piping or trim.
If you take it slow, it’s not as hard as it looks. Victoria is a vintage beauty and she’s just perfect! Now that I’ve gotten my feet wet (so to speak), I’m anxious to try something a little harder next time.
Lots of love,
Linked up here:
My friends, I owe you a long-overdue tutorial on the backsplash install as a part of my kitchen makeover. This project was my very first attempt at DIY tiling and I was a bit nervous to experiment in the kitchen, of all places. Tile isn’t exactly something that’s easy to fix if you make a mistake.
I chose a small subway-patterned glass tile in a sea blue color. I love a good deal, so I was ecstatic when I saw this beautiful tile on clearance at my local Home Depot a couple years ago (yes, it’s been sitting in my garage this whole time).
I am IN LOVE with glass tile! The way the light bounces off the backsplash now brings me so much joy! It’s like jewelry for your kitchen — a little bling!
So the question is… How did I do it? Well, as I said, I was a bit nervous to experiment and do my first tiling job in the kitchen so I took the easy way out and used a fab product called SimpleMat Tile Setting Mat.
It’s basically a “sticker” of sorts that you use in place of mixing thin set. Super easy and no mess! It is quite a bit more expensive than thin set, but still way cheaper than hiring a pro! The instructions on the back are easy to follow and dummy-proof. Trust me! *wink*
After setting the tile in place, I used a grout that came pre-mixed in a tub. You’ll push the grout into the tile spaces with a tool called a float, wipe off the excess, and wait until the next day for the grout to dry before polishing the surface. Step-by-step directions are included with both the tile setting mat as well as the pre-mixed grout, which makes this project way easy for an eager DIY enthusiast!
My biggest tip for this project: make sure you wipe all your edges clean before letting the grout dry. There are a couple spots where I wish I would have been more of a perfectionist. Other than that, I love love love the results and would totally do it again in a heartbeat!
Check out all the posts in the Kitchen Makeover series!
Lots of love,